• The SKY EYE is a simplified, motorized camera mount. It is particularly useful on platforms with inherent control of one axis, but need assistance in controlling the other axis, such as rotor-craft and monopods. It is equally useful as a variable speed object turntable for videography. The unit is small in size, resistant to shock and weather, and has good motion control.

• SKY EYE will hold and aim your camcorder or still camera while allowing the safe operation of your aircraft. Its remote controller allows wingtip or other distant viewpoints.

• SKY EYE allows 360 degrees of motion.

• A 12 volt D.C. gearmotor provides plenty of torque to position your camera against the airstream.

• The JOCKEY SWITCH allows for independent motion and speed control.

1. Power source: 12 volts D.C.. Power supply not included
2. Gearmotor load drain: One motor draws 0.5 full load amps. Factory rated 3.4 rpm motors turn an actual 5 rpm full speed under usual loads.
3. Jockey switch: Provides separate motion and speed control.
4. Remote cable: Cut to customer specifications if needed. Standard length 15 feet (4.575 meters). $2.00 per foot (.305 meters) for lengths over 15 feet.
5. Dimensions: Basically a 5" (12.7 centimeter) diameter by 3" tall cylinder; Overall 16" by 9.5" including all bracketry.
6. Weight: Approximately 4.5 pounds (2.043Kg).
7. Capacity: Approximately 6 pound (2.742 kilograms) camera payload limit.
8. Clamping: A Bogen clamp is used which will work on up to a 2.50" (6.35 centimeters) outside diameter tube or table edge.
9. Pivot joint: This SKY EYE model uses its pivot shaft to convert from pan to tilt mode. This shaft is also used to compensate for angle of the supporting structure.

SKY EYE is backed by a 30 day money back guarantee if it does not meet your requirements.

• Standard System Price is $425.00. System includes motor drive, camera L-bracket, quick-clamp arm, 15 foot control cable, jockey switch controller, and manual.

BACK to SkyEye Corporation

BACK to SkyEye Products